Investigation into the relationship between tool-wear and cutting environments when milling an austenitic stainless steel and En32 low carbon steel

Author： Stanford M   Lister P.M.  

Publisher： Emerald Group Publishing Ltd

ISSN： 0036-8792

Source： Industrial Lubrication and Tribology, Vol.57, Iss.2, 2005-02, pp. : 73-79

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Investigation into the relationship between tool-wear and cutting environments when turning EN32 steel

By Stanford M   Lister P.M.  

Industrial Lubrication and Tribology, Vol. 56, Iss. 2, 2004-03 ,pp. : 114-121

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

An investigation of adhering layer formation during tool wear progression in turning of free-cutting stainless steel

By Fang X.D.   Zhang D.  

Wear, Vol. 197, Iss. 1, 1996-09 ,pp. : 169-178

Elsevier

Access to resources Recommend Favorite

Investigation of Chip and Surface Roughness when Milling AISI304 Stainless Steel

By  

Materials Science Forum, Vol. 2017, Iss. 889, 2017-04 ,pp. : 152-158

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Variable Pitch on Cutting Temperature, Cutting Forces and Surface Roughness Using Nitico30 Cutting Tool when End Milling of Stainless Steel 316L

By  

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite

Interface characterization of CO2 laser welded austenitic stainless steel and low carbon steel couple

By Caligulu Ugur   Taskin Mustafa   Kejanli Haluk   Orhan Ayhan  

Industrial Lubrication and Tribology, Vol. 64, Iss. 4, 2012-06 ,pp. : 196-207

Emerald Group Publishing Ltd

Access to resources Recommend Favorite