A 3D microfluidic device fabrication method using thermopress bonding with multiple layers of polystyrene film

E-ISSN： 1361-6439|25|6|65005-65014

ISSN： 0960-1317

Source： Journal of Micromechanics and Microengineering, Vol.25, Iss.6, 2015-06, pp. : 65005-65014

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

In this article, we present a fabrication method that is capable of making (3D) microfluidic devices with multiple layers of homogeneous polystyrene (PS) film. PS film was chosen as the primary device material because of its advantageous features for microfluidics applications. Thermopress is used as a bonding method because it provides sufficient bonding strength while requiring no heterogeneous bonding materials. By aligning and sequentially stacking multiple layers (3 to 20) of patterned PS film that were achieved by a craft cutter, complicated 3D structured microfluidic devices can be fabricated by multiple steps of thermopress bonding. The smallest feature that can be achieved with this method is approximately 100 μm, which is limited by the resolution of the cutter (25 μm) as well as the thickness of the PS films. Bonding characteristics of PS films are provided in this article, including a PS film bonding strength test, bonding precision assessment, and PS surface wettability manipulation. To demonstrate the capability of this method, the design, fabrication, and testing results of a 3D interacting L-shaped passive mixer are presented.