Influence of machining parameters on surface roughness in finish cut of WEDM

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.34, Iss.5-6, 2007-09, pp. : 538-546

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

The effect of machining parameters on surface roughness and material removal rate with cryogenic treated wire in WEDM

By Kapoor Jatinder Khamba Jaimal Singh Singh Sehijpal

International Journal of Machining and Machinability of Materials, Vol. 12, Iss. 1-2, 2012-08 ,pp. : 126-141

Inderscience Publishers

Access to resources Recommend Favorite

Analysis of machining parameters effects on surface roughness: a review

By Khorasani A. Mahyar

International Journal of Computational Materials Science and Surface Engineerin, Vol. 5, Iss. 1, 2012-09 ,pp. : 68-84

Inderscience Publishers

Access to resources Recommend Favorite

Influence of the Cutting Parameters on the Surface Roughness when Machining Hardened Steel with Ceramic and PCBN Cutting Tools

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 19-22

Trans Tech Publications

Access to resources Recommend Favorite

Process Parameter Optimization for MRR and Surface Roughness during Machining LM6 Aluminum MMC on WEDM

Advanced Engineering Forum, Vol. 2017, Iss. 20, 2017-02 ,pp. : 42-50

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Process Parameters on Material Removal Rate and Surface Roughness in Wedm of H-13 Die Tool Steel

Advanced Engineering Forum, Vol. 2018, Iss. 28, 2018-08 ,pp. : 55-66

Trans Tech Publications

Access to resources Recommend Favorite