Test and Analysis of Low Temperature Air Cutting Performance to Difficult-to-Machine Materials

E-ISSN： 1662-9795|2015|667|155-161

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.667, 2016-02, pp. : 155-161

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

High Speed Machining of Difficult-to-Machine Materials under Different Lubrication Conditions

Key Engineering Materials, Vol. 2014, Iss. 625, 2014-10 ,pp. : 60-65

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Supplying Oil Mist and Water Mist with Cold Air on Cutting Force and Temperature in End Milling of Difficult-to-Cut Materials

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 255-260

Trans Tech Publications

Access to resources Recommend Favorite

Application of Taguchi Method to Optimization of Cutting Force and Temperature during Turning of Difficult to Cut Materials

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 114-118

Trans Tech Publications

Access to resources Recommend Favorite

Research on the Influence of Tool Wear on Cutting Performance in High-Speed Milling of Difficult-to-Cut Materials

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1129-1134

Trans Tech Publications

Access to resources Recommend Favorite

The Application and Performance of Diamond and PCBN Tools in Difficult-to-Cut Materials

Solid State Phenomena, Vol. 2017, Iss. 263, 2017-10 ,pp. : 90-96

Trans Tech Publications

Access to resources Recommend Favorite