The Impact of Torsion on the Bending Curve during 3D Bending of Thin-Walled Tubes - A Case Study on Forming Helices

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|651|1595-1601

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 1595-1601

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Study and Build-Up of Deformation Zone at Cutting of Thin-Walled Tube by Torsion

By  

Key Engineering Materials, Vol. 2017, Iss. 746, 2017-08 ,pp. : 16-21

Trans Tech Publications

Access to resources Recommend Favorite

Mechanical Performance of Polymer-Matrix Laminate Reinforced with 3D Fabric during Three-Point Impact Bending

By  

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 193-196

Trans Tech Publications

Access to resources Recommend Favorite

The Deformation Process of Thin-Walled Box Beams Joined by Rivets under Three-Point Bending

By  

Solid State Phenomena, Vol. 2016, Iss. 254, 2016-10 ,pp. : 283-289

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Boosting Velocity on Forming Quality of High-Strength TA18 Titanium Alloy Tubes in Numerical Control Bending

By  

Key Engineering Materials, Vol. 2017, Iss. 748, 2017-09 ,pp. : 197-201

Trans Tech Publications

Access to resources Recommend Favorite

Thin-walled composite tubes using fillers subjected to quasistatic axial compression

By  

IOP Conference Series: Materials Science and Engineering, Vol. 78, Iss. 1, 2015-04 ,pp. : 201-212

IOP Publishing

Access to resources Recommend Favorite