Publisher: Trans Tech Publications
E-ISSN: 1662-9795|2015|662|173-176
ISSN: 1013-9826
Source: Key Engineering Materials, Vol.2015, Iss.662, 2015-10, pp. : 173-176
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Local plastic deformation in cutting zone during turning is affected by technological conditions of the processes. Therefore it is needful to know detail structure changes of plastic deformed material during machining. It is localised, asymmetric deformation which operates at very large strains and exceptionally high strain rates. Three areas of intensive local plastic deformation in cutting zone were observed: the primary area of plastic deformation in shear plane, the secondary area of plastic deformation caused by friction of chip to tool face and the tertiary area of plastic deformation caused by friction of tool to machined surface. Local strain in these three areas was estimated by measurement of deformation of grains on metallographic cut. The effect of grains boundaries self-orientation caused by grains deformation was evaluated using stereology. But the orientation is not the same as deformation and so a correlation between the grain deformation and grain orientation was used. The turning piece was made of CK45 (1.0503) carbon steel. The specimen of cutting zone was obtained by using internal stress method.
Related content
Analysis of Local Plastic Deformation of Machined Surface
Defect and Diffusion Forum, Vol. 2016, Iss. 368, 2016-08 ,pp. :
Study and Build-Up of Deformation Zone at Cutting of Thin-Walled Tube by Torsion
Key Engineering Materials, Vol. 2017, Iss. 746, 2017-08 ,pp. :
Influence of Various Cutting Fluids on Energy Consumption during Turning
Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. :