Influence of Process Conditions on the Local Shrinkage and on the Pressure Evolution inside the Mold Cavity of the Injection Molded Polypropylene in Two Modifications - PP Homopolymer; 40 % Talc Filled PP

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|669|11-18

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.669, 2016-02, pp. : 11-18

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Evaluation of Mechanical Properties of Surface Layer Injection Molded Polypropylene by Nanoindentation Test

By  

Key Engineering Materials, Vol. 2016, Iss. 699, 2016-08 ,pp. : 86-90

Trans Tech Publications

Access to resources Recommend Favorite

Polypropylene Based Piezo Ceramic Compounds for Micro Injection Molded Sensors

By  

Key Engineering Materials, Vol. 2017, Iss. 742, 2017-08 ,pp. : 807-814

Trans Tech Publications

Access to resources Recommend Favorite

Simulation of the sintering densification and shrinkage behavior of powder-injection-molded 17-4 PH stainless steel

By Kwon Young-Sam   Wu Yunxin   Suri Pavan   German Randall  

Metallurgical and Materials Transactions A, Vol. 35, Iss. 1, 2004-01 ,pp. : 257-263

Springer Publishing Company

Access to resources Recommend Favorite

Influence of Technological Parameters on Surface Quality of Injection-Molded Parts

By  

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 131-136

Trans Tech Publications

Access to resources Recommend Favorite

Modelling of shrinkage cavity defects during the wheel and belt casting process

By  

IOP Conference Series: Materials Science and Engineering, Vol. 33, Iss. 1, 2012-07 ,pp. : 467-476

IOP Publishing

Access to resources Recommend Favorite