Effect of Nickel Addition Study on the Mechanical Properties of the (Fe₃C-Ni) Alloy Obtained by Solid Phase Compaction and Sintering

Publisher： Trans Tech Publications

E-ISSN： 1663-4144|2017|32|18-24

ISSN： 1663-3571

Source： International Journal of Engineering Research in Africa, Vol.2017, Iss.32, 2017-10, pp. : 18-24

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Composite Compacts of Fe/Fe₃O₄ Type Obtained by Mechanical Milling-Sintering-Annealing Route

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 3-8

Trans Tech Publications

Access to resources Recommend Favorite

Nanocrystalline/Nanosized Fe₃O₄ Powder Obtained by Mechanosynthesis

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 9-14

Trans Tech Publications

Access to resources Recommend Favorite

Research of the Fe₂O₃ Powder Granulation Effect on BaFe₁₂O₁₉ Firing Temperature

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 29-36

Trans Tech Publications

Access to resources Recommend Favorite

Synthesis of Fe₇₅Si_20-xB₅M_x (M=Ti, Ta or Zr) Powders by Wet Mechanical Milling

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 54-58

Trans Tech Publications

Access to resources Recommend Favorite

The Influence of Milling Conditions on the Ni₃Fe Alloyed Powder

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 75-82

Trans Tech Publications

Access to resources Recommend Favorite