Influence of Coolant Application Direction on the Cutting Performance of Ceramic Tool in High-Speed Air-Jet-Assisted Machining of Inconel 718

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|749|87-93

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.749, 2017-09, pp. : 87-93

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Self-Sharpening Failure Characteristic of a Si3N4 Ceramic Tool in High Speed Cutting of Inconel 718

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1135-1142

Trans Tech Publications

Access to resources Recommend Favorite

Influence of the Coated Carbide Grade on the Cutting Tool Life When Machining Inconel 718

By  

Key Engineering Materials, Vol. 2016, Iss. 674, 2016-02 ,pp. : 271-276

Trans Tech Publications

Access to resources Recommend Favorite

Research on the Influence of Tool Wear on Cutting Performance in High-Speed Milling of Difficult-to-Cut Materials

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1129-1134

Trans Tech Publications

Access to resources Recommend Favorite

Air Jet Assisted End Milling of Titanium Alloy Ti-6Al-4V ELI at High Cutting Speed

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 168-173

Trans Tech Publications

Access to resources Recommend Favorite

Oxidation of Inconel 718 in Air at High Temperatures

By Greene G.A.   Finfrock C.C.  

Oxidation of Metals, Vol. 55, Iss. 5-6, 2001-06 ,pp. : 505-521

Springer Publishing Company

Access to resources Recommend Favorite