Experimental validation of a simple, low-cost, T-junction droplet generator fabricated through 3D printing

Author： Donvito Lidia   Galluccio Laura   Lombardo Alfio   Morabito Giacomo   Nicolosi Alfio   Reno Marco  

Publisher： IOP Publishing

E-ISSN： 1361-6439|25|3|35013-35018

ISSN： 0960-1317

Source： Journal of Micromechanics and Microengineering, Vol.25, Iss.3, 2015-03, pp. : 35013-35018

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Evaluation of Capacitive Markers Fabricated by 3D Printing, Laser Cutting and Prototyping

By Kreimeier Julian   Bielmeier Thomas   Götzelmann Timo  

Inventions, Vol. 3, Iss. 1, 2018-01 ,pp. : 9-9

MDPI

Access to resources Recommend Favorite

Calibrate Multiple Consumer RGB-D Cameras for Low-Cost and Efficient 3D Indoor Mapping

By Chen Chi   Yang Bisheng   Song Shuang   Tian Mao   Li Jianping   Dai Wenxia   Fang Lina  

Remote Sensing, Vol. 10, Iss. 2, 2018-02 ,pp. : 328-328

MDPI

Access to resources Recommend Favorite

Toward low-cost 3D automatic pavement distress surveying: the close range photogrammetry approach

By Ahmed Mahmoud   Haas C.T.   Haas Ralph  

Canadian Journal of Civil Engineering, Vol. 38, Iss. 12, 2011-12 ,pp. : 1301-1313

NRC Research Press

Access to resources Recommend Favorite

Photoresponse of Tunneling Conduction Through Pb(Ti,Zr)O3/SrTiO3 Junction at Low Temperature

By WATANABE YUKIO   OKANO MOTOCHIKA  

Integrated Ferroelectrics, Vol. 62, Iss. 1, 2004-01 ,pp. : 49-54

Taylor & Francis Ltd

Access to resources Recommend Favorite

Evaluation of 3D printing for dies in low volume forging of 7075 aluminum helicopter parts

By Shivpuri R   Cheng X   Agarwal K   Babu S  

Rapid Prototyping Journal, Vol. 11, Iss. 5, 2005-05 ,pp. : 272-277

Emerald Group Publishing Ltd

Access to resources Recommend Favorite