Evaluation of Capacitive Markers Fabricated by 3D Printing, Laser Cutting and Prototyping

Author： Kreimeier Julian Bielmeier Thomas Götzelmann Timo

Publisher： MDPI

E-ISSN： 2411-5134|3|1|9-9

ISSN： 2411-5134

Source： Inventions, Vol.3, Iss.1, 2018-01, pp. : 9-9

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Options for additive rapid prototyping methods (3D printing) in MEMS technology

By Lifton Victor A. Lifton Gregory Simon Steve

Rapid Prototyping Journal, Vol. 20, Iss. 5, 2014-08 ,pp. : 403-412

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Categorical prototyping: incorporating molecular mechanisms into 3D printing

Nanotechnology, Vol. 27, Iss. 2, 2016-01 ,pp. : 24002-24009

IOP Publishing

Access to resources Recommend Favorite

Monolithic transparent 3D dielectrophoretic micro-actuator fabricated by femtosecond laser

By Yang Tao Bellouard Yves

Journal of Micromechanics and Microengineering, Vol. 25, Iss. 10, 2015-10 ,pp. : 105009-105016

IOP Publishing

Access to resources Recommend Favorite

Experimental validation of a simple, low-cost, T-junction droplet generator fabricated through 3D printing

By Donvito Lidia Galluccio Laura Lombardo Alfio Morabito Giacomo Nicolosi Alfio Reno Marco

Journal of Micromechanics and Microengineering, Vol. 25, Iss. 3, 2015-03 ,pp. : 35013-35018

IOP Publishing

Access to resources Recommend Favorite

Characterization and evaluation of a PMMA-based 3D printing process

By Polzin Christian Spath Sebastian Seitz Hermann

Rapid Prototyping Journal, Vol. 19, Iss. 1, 2013-01 ,pp. : 37-43

Emerald Group Publishing Ltd

Access to resources Recommend Favorite