Hybrid Microwave-Assisted Rapid Sintering Process for Fabrication of Sn-0.7Cu+1.0wt.%Si

E-ISSN： 1662-9752|2014|803|305-309

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2014, Iss.803, 2015-01, pp. : 305-309

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Microstructural Features of Sn-3.0Ag-0.7Cu Alloy Prepared by Conventional and Microwave Sintering

Materials Science Forum, Vol. 2017, Iss. 899, 2017-08 ,pp. : 412-417

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Microwave and Conventional Heating on Sintering Behavior of Cu-10vol.%SiC Nanocomposites

Materials Science Forum, Vol. 2015, Iss. 819, 2015-07 ,pp. : 274-279

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of mechanical properties and microstructure of Al(1 wt.%Si) and Al(1 wt.%Si, 0.5 wt.%Cu) thin films

By Bader S. Kalaugher E.M. Arzt E.

Thin Solid Films, Vol. 263, Iss. 2, 1995-07 ,pp. : 175-184

Elsevier

Access to resources Recommend Favorite

Effect of Si₃N₄ Addition on the Properties of Sn-1.0Ag-0.7Cu Solder Alloy

Materials Science Forum, Vol. 2015, Iss. 819, 2015-07 ,pp. : 167-172

Trans Tech Publications

Access to resources Recommend Favorite

Characterization of pit morphology of sputtered Al-1wt.%Si-0.5wt.%Cu alloy thin film

By Pyun S.-I. Orr S.-J. Nam S.-W.

Thin Solid Films, Vol. 279, Iss. 1, 1996-06 ,pp. : 7-10

Elsevier

Access to resources Recommend Favorite