Influence of the polypropylene structure on the replication of nanostructures by injection molding

Author： Vera Julie Brulez Anne-Catherine Contraires Elise Larochette Mathieu Valette Stéphane Benayoun Stéphane

E-ISSN： 1361-6439|25|11|115027-115036

ISSN： 0960-1317

Source： Journal of Micromechanics and Microengineering, Vol.25, Iss.11, 2015-11, pp. : 115027-115036

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Surface microstructure replication in injection molding

By Theilade Uffe Hansen Hans

The International Journal of Advanced Manufacturing Technology, Vol. 33, Iss. 1-2, 2007-05 ,pp. : 157-166

Springer Publishing Company

Access to resources Recommend Favorite

Injection molding of high aspect ratio sub-100 nm nanostructures

By Matschuk Maria Larsen Niels B

Journal of Micromechanics and Microengineering, Vol. 23, Iss. 2, 2013-02 ,pp. : 25003-25012

IOP Publishing

Access to resources Recommend Favorite

Hydrogen silsesquioxane mold coatings for improved replication of nanopatterns by injection molding

By Matschuk Maria Kafka Jan Pranov Henrik J Larsen Niels B Matschuk Maria

Journal of Micromechanics and Microengineering, Vol. 25, Iss. 3, 2015-03 ,pp. : 35018-35026

IOP Publishing

Access to resources Recommend Favorite

Optimization of injection molding process for contour distortions of polypropylene composite components by a radial basis neural network

By Shie Jie-Ren

The International Journal of Advanced Manufacturing Technology, Vol. 36, Iss. 11-12, 2008-04 ,pp. : 1091-1103

Springer Publishing Company

Access to resources Recommend Favorite

Powder injection molding 440C stainless steel

By Li Duxin Hou Haitao Liang Lianghua Lee Kun

The International Journal of Advanced Manufacturing Technology, Vol. 49, Iss. 1-4, 2010-07 ,pp. : 105-110

Springer Publishing Company

Access to resources Recommend Favorite