Slurry Preparation and Hot Tearing Susceptibility of A201 Aluminum Alloy in Rheological Die Casting

E-ISSN： 1662-9779|2019|285|311-317

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2019, Iss.285, 2019-02, pp. : 311-317

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Addition of Swarf to Produce a Semi-Solid Slurry during High Pressure Die-Casting of AS9U3 Aluminum Alloy

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 271-276

Trans Tech Publications

Access to resources Recommend Favorite

Apparent Viscosity and Rheological Behavior of Aluminum-Alloy Slurry Containing Nano-Sized SiC Particles

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 391-397

Trans Tech Publications

Access to resources Recommend Favorite

Impact of Intensification Pressure and Grain Refiner on the Hot Tearing Susceptibility of a Semi-Solid Cast Al-Zn-Mg-Cu Alloy

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 283-289

Trans Tech Publications

Access to resources Recommend Favorite

Preparation of Semi-Solid A390 Aluminum Alloy Slurry through a Serpentine Pouring Channel

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 169-175

Trans Tech Publications

Access to resources Recommend Favorite

Microstructural Development of Aluminum A201 Alloy Semi-Solid Processing Feedstock Produced by Different Routes

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 302-310

Trans Tech Publications

Access to resources Recommend Favorite