Publisher： Elsevier
Founded in： 1961
Total resources： 4
E-ISSN： 1879-2170
ISSN： 0890-6955
Subject： TH13 mechanical parts and transmission
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
International Journal of Machine Tools and Manufacture
Menu
NURBS interpolator for constant material removal rate in open NC machine tools
By Tikhon M., Ko T.J., Lee S.H., Sool Kim H. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.
Access to resources
Recommend
Gundrill life improvement for deep-hole drilling on manganese steel
By Zhang W., He F., Xiong D. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.An experimental investigation into soft-pad grinding of wire-sawn silicon wafers
By Pei Z.J., Kassir S., Bhagavat M., Fisher G.R. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.By Liu C.-H., Jywe W.-Y., Chen C.-K. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.Measurement of spindle thermal errors in machine tool using hemispherical ball bar test
By Yang S.-H., Kim K.-H., Park Y.K. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.On the mechanics of the grinding process, Part II-thermal analysis of fine grinding
By Hou Z.B., Komanduri R. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.An investigation of tearing failure in fine-blanking process using coupled thermo-mechanical method
By Chen Z.H., Tang C.Y., Lee T.C. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.By Gorana V.K., Jain V.K., Lal G.K. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.A model for detection of the eroding surface based on discharge parameters
By Valentincic J., Junkar M. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.By M'Saoubi R., Chandrasekaran H. in (2004)
International Journal of Machine Tools and Manufacture , Vol. 44, Iss. 2, 2004-02 , pp.
Previous
Next