One- and two-component micro powder injection moulding derived from thermoplastic microreplication

By Piotter V.   Mueller T.   Plewa K.   Ritzhaupt-Kleissl H.-J.   Ruh A.   Hausselt J.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 287-292

Maney Publishing

Access to resources Recommend Favorite

Mould fouling of elastomers during injection moulding

By Hornsby P. R.   Singh I.   Daley J. R.   Firth J.  

Plastics, Rubber and Composites, Vol. 35, Iss. 8, 2006-10 ,pp. : 331-339

Maney Publishing

Access to resources Recommend Favorite

Custom Painting by Means of Powder Coating and Localized Heating

By Quadrini Fabrizio   Santo Loredana   Tagliaferri Vincenzo   Trovalusci Federica  

Polymer-Plastics Technology and Engineering, Vol. 49, Iss. 2, 2010-01 ,pp. : 164-168

Taylor & Francis Ltd

Access to resources Recommend Favorite

Using injection moulding simulation to develop environmentally friendly products

By Thomas A. R.   Speight R. G.   Annareddy M.  

Plastics, Rubber and Composites, Vol. 37, Iss. 2-4, 2008-05 ,pp. : 184-189

Maney Publishing

Access to resources Recommend Favorite

Quality characteristic improvement of an injection moulding product made from blends plastic by optimizing the injection moulding parameters using Taguchi method

By Kamaruddin Shahrul  

International Journal of Plastics Technology, Vol. 14, Iss. 2, 2010-12 ,pp. : 152-166

Springer Publishing Company

Access to resources Recommend Favorite