Wall Thickness Distribution during a Combined Tube Spinning and Bending Process

E-ISSN： 1662-9795|2015|651|1614-1619

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 1614-1619

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Simulation on the Effect of Bottle Wall Thickness Distribution using Blow Moulding Technique

IOP Conference Series: Materials Science and Engineering, Vol. 114, Iss. 1, 2016-02 ,pp. : 29-34

IOP Publishing

Access to resources Recommend Favorite

Feasibility of Motion-Capture Techniques Applied to Tube Bending

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1128-1133

Trans Tech Publications

Access to resources Recommend Favorite

Predicting Tube Ovalization in Cold Bending: An Analytical Approach

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1146-1152

Trans Tech Publications

Access to resources Recommend Favorite

Evaluation of Drawing Force and Thickness Distribution in the Deep-Drawing Process with Variable Blank-Holding

Key Engineering Materials, Vol. 2015, Iss. 639, 2015-04 ,pp. : 33-40

Trans Tech Publications

Access to resources Recommend Favorite

Investigation on Hole Punching Process with Combined Punch to Improve Surface Quality during the Materials Forming Process

Key Engineering Materials, Vol. 2017, Iss. 737, 2017-07 ,pp. : 77-82

Trans Tech Publications

Access to resources Recommend Favorite