Effect of Relative Density and Strain Rate on the Deformation Behaviour Ni-Ti Foam Made through Powder Metallurgy Route Using NH4(HCO3) as Space Holder

Publisher： Trans Tech Publications

E-ISSN： 2234-991x|2016|15|35-55

ISSN： 2234-9898

Source： Advanced Engineering Forum, Vol.2016, Iss.15, 2016-03, pp. : 35-55

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Influence of Milling Conditions on the Ni3Fe Alloyed Powder

By  

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 75-82

Trans Tech Publications

Access to resources Recommend Favorite

Nanocrystalline/Nanosized Fe3O4 Powder Obtained by Mechanosynthesis

By  

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 9-14

Trans Tech Publications

Access to resources Recommend Favorite

Research of the Fe2O3 Powder Granulation Effect on BaFe12O19 Firing Temperature

By  

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 29-36

Trans Tech Publications

Access to resources Recommend Favorite

Composite Compacts of Fe/Fe3O4 Type Obtained by Mechanical Milling-Sintering-Annealing Route

By  

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 3-8

Trans Tech Publications

Access to resources Recommend Favorite

Analysis on the Factors of Surface Morphologies on Si3N4 Ceramic Internal Grinding

By  

International Journal of Engineering Research in Africa, Vol. 2017, Iss. 31, 2017-08 ,pp. : 44-52

Trans Tech Publications

Access to resources Recommend Favorite