Simulation of cutting forces in ball-end milling

Publisher： Elsevier

ISSN： 0736-5845

Source： Robotics and Computer-Integrated Manufacturing, Vol.19, Iss.1, 2003-02, pp. : 99-106

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Study of Coated Carbide Ball End Milling Tools on Inconel 718 Using Numerical Simulation Analysis to Attain Cutting Force and Temperature Predictive Models at the Cutting Zone

Materials Science Forum, Vol. 2017, Iss. 882, 2017-02 ,pp. : 28-35

Trans Tech Publications

Access to resources Recommend Favorite

Estimation of Machining Error Caused by Deflection of Tool Using Cutting Force in Ball End Milling of Inclined Surface

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 525-530

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Variable Pitch on Cutting Temperature, Cutting Forces and Surface Roughness Using Nitico30 Cutting Tool when End Milling of Stainless Steel 316L

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite

Cutting Parameters Optimization Based on Cutting Force Spectrum when Ball Milling A880 Gas Turbine Blade Profiles

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 578-583

Trans Tech Publications

Access to resources Recommend Favorite

Cutting fluid efficiency in end milling of AISI 304 stainless steel

By Abou-El-Hossein K.A.

Industrial Lubrication and Tribology, Vol. 60, Iss. 3, 2008-05 ,pp. : 115-120

Emerald Group Publishing Ltd

Access to resources Recommend Favorite