Increased Shape Stability and Porosity of Highly Porous Injection‐Molded Titanium Parts

Publisher： John Wiley & Sons Inc

E-ISSN： 1527-2648|17|11|1579-1587

ISSN： 1438-1656

Source： ADVANCED ENGINEERING MATERIALS (ELECTRONIC), Vol.17, Iss.11, 2015-11, pp. : 1579-1587

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Flowing simulation of injection molded parts with micro-channel

By Cui Zhi-xiang   Si Jun-hui   Liu Chun-tai   Shen Chang-yu  

Applied Mathematics and Mechanics, Vol. 35, Iss. 3, 2014-03 ,pp. : 269-276

Springer Publishing Company

Access to resources Recommend Favorite

Correlation between morphological properties and thermal conductivity of injection‐molded polyamide 46

By  

POLYMER ENGINEERING & SCIENCE, Vol. 32-3888, Iss. 10, 2015-10 ,pp. : 2231-2236

John Wiley & Sons Inc

Access to resources Recommend Favorite

Correlation between morphological properties and thermal conductivity of injection‐molded polyamide 46

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 10, 2015-10 ,pp. : 2231-2236

John Wiley & Sons Inc

Access to resources Recommend Favorite

Process‐induced phase and crystal morphologies in water‐assisted injection molded polypropylene/polymeric β‐nucleating agent blend parts

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 7, 2015-07 ,pp. : 1698-1705

John Wiley & Sons Inc

Access to resources Recommend Favorite

Novel foaming method to fabricate microcellular injection molded polycarbonate parts using sodium chloride and active carbon as nucleating agents

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 7, 2015-07 ,pp. : 1634-1642

John Wiley & Sons Inc

Access to resources Recommend Favorite